Specifications Dimensions: 36.5mm(L) x 36.5mm(W) x 7mm(H), recommended for quads at 3.5″ or above MountinPattern: 25.5 x 25.5mm, 3mm hole diameter Power Input: 3S – 6S Lipo Weight: 10.1g FLIGHT CONTROLLER USB Connection: Need to solder a USB TYPE-C module to D , D-, GND pads. 5V Output: 4 groups of 5V output. The total current load is 2.5A. SmartPort: Use any TX pad of UART for the SmartPort feature. BLE Bluetooth: Supported. Used for parameter configuration UART: Full UART * 4(UART1, UART2, UART3, UART4) 3.3V Output: Supported. Up to 500mA current load. Supported Flight Controller: BetaFlight(Default) Firmware Target Name: SPEEDYBEE F745AIO Buzzer: BZ and BZ- pad used for 5V Buzzer BetaFlight Camera Control Pad: Yes(CC pad) Flash FC Firmware Wirelessly: Supported Download/Analyze Blackbox: Supported BOOT Button: Used to enter DFU mode Current Sensor: Supported. Scale=256 DJI Air Unit 6-pin Connector: Built-in. LED Pad Used for WS2812 LED ESC Telemetry UART: None RSSI Input: Not supported Flash(for BlackBox): 8MB ESC Signal Pads M1 – M4 IMU(Gyro): MPU6000 Barometer: BMP280 MCU: STM32F745 9V Output: None OSD: Supported I2C: Supported. ESC Current Sensor: Supported(Sacle=256) ESC Protocol: DSHOT300/600 Firmware: BLHeli_S JH40 Continuous Current: 35A Burst Current: 45A(5S) Power Input: 3-6S LiPo Power Output: VBAT
